Observation of a phase transition in KTaO3 induced by residual niobium impurities

Abstract

We report the observation of a phase transition in a KTaO3 crystal, corresponding to a paraelectric-to-ferroelectric transition. The crystal was placed inside a copper cavity to form a dielectric-loaded microwave cavity, and the transition was observed to occur near 134 K. As the cavity was cooled, the frequencies of both transverse electric and transverse magnetic resonant modes decreased (corresponding to an increase in permittivity). The mode frequencies converge at the transition temperature (near 134 K) and, below this point, reverse their tuning direction, increasing their frequency with decreasing temperature. This behaviour corresponds to a decrease in dielectric permittivity and is atypical for pure KTaO3. To investigate further, we conducted impurity analysis using Laser Ablation inductively coupled mass spectrometry (LA-ICPMS), revealing a significant concentration ( 7\%) of niobium (Nb) in the crystal. This suggests that the observed phase transition is driven by residual Nb impurities, which induce ferroelectricity in an otherwise paraelectric host. Similar crystals with a lower concentration (< 2\%) did not undergo a phase transition but exhibited a loss peak at this temperature. These findings have practical implications for the design of tunable devices, for example, resonator-based dark matter detectors, where low-loss material phase stability and tunability are crucial.

0

Turn this paper into a full lesson

ArcXiv compiles a staged curriculum from this paper: 8-12 lessons across beginner → advanced, synthesised section guides, visuals, flashcards, a quiz, exercises, and on-demand deep dives per section. Grounded in the abstract, never invented.

Discussion (0)

Sign in to join the discussion.

Loading comments…