Transverse Impedance Bench Measurements in NLC/JLC Accelerating Structures
N. Baboi, G. B. Bowden, R. M. Jones, S. G. Tantawi, J. R. Lewandowski
Abstract
The wire method is a more rapid and less costly method to measure impedances of RF components compared to methods using a beam. A setup using a single displaced wire to excite and measure transverse resonant modes in accelerating structures for the Next Linear Collider/ Japanese Linear Collider (NLC/JLC) has been built. The RF signal is coupled into and out of the structure using two matching sections with a broadband frequency from 11 to 18 GHz. Their contribution to the scattering parameter is minimized by a calibration technique. A standing wave structure has been measured. Difficulties in accurately predicting the modal loss factors were encountered related to the approximations made and to experimental issues. The measurements are presented and comparisons with simulations are made.
Create a lesson
Related papers
Physics of stabilization and dynamic control of CW magnetrons for superconducting accelerators
G. Kazakevich, R. P. Johnson, I. Gonin et al.
AloHEP Software: A luminosity optimizer for High Energy Physics colliders
Burak Dagli, Yigitali Karaca
Development of a continuous-wave photocathode very-high-frequency electron gun for S3FEL
Lianmin Zheng, Yitong Duan, Yuanyuan Qin et al.
Limits on energy recovery for positron acceleration in a warm plasma column
Max Varverakis, Spencer Gessner, Severin Diederichs et al.
Construction of Approximate Invariants Across Nonlinear Resonances
Yongjun Li, Derong Xu, Yue Hao et al.
Effect of transition layer on wakefield in plasma waveguide
Peter Markov, Kostyantyn Galaydych, Gennadiy Sotnikov