Open-Source Multi-Wire SPI Readout for Wearable Ultrasound Probes

Abstract

Wearable ultrasound probes must transfer increasingly large acquisition payloads while maintaining compact, low-power electronics. In TinyProbe, the current bottleneck in data transfer occurs between the acquisition FPGA and the wireless system controller. This work presents an open-source, multi-wire SPI readout interface that uses serial command and address phases followed by a build-time-selectable dual- or quad-lane payload phase that is intended to address this bottleneck by increasing the potential bandwidth over the wifi limit while retaining compatibility with the Microcontroller-centric wearable US architecture. The interface emulates a serial flash memory, enabling compatibility with a broad range of microcontroller families and their existing peripheral interfaces. On the FPGA, the data path connects the existing acquisition FIFOs to the SPI interface through clock-domain crossing, sample reshaping, and packing into 32-bit words. Dual-SPI readout is integrated into the existing IGLOO2/SiWG917 TinyProbe architecture and verified at an SCLK frequency of 5 MHz. A separate Kria K26 testbed is used to characterize the FPGA SPI interface independently of the acquisition and wireless subsystems, demonstrating error-free transfers at SCLK frequencies up to 66 MHz. These measurements identify the SiWG917 multi-lane SPI implementation as the next bandwidth-limiting component and motivate a future upgrade of the system controller. The HDL and MCU implementations are released under a permissive open-source license.