SQUID based resistance bridge for shot noise measurement on low impedance samples
X. Jehl, P. Payet-Burin, C. Baraduc, R. Calemczuk, M. Sanquer
Abstract
We present a resistance bridge which uses a SQUID to measure the shot noise in low impedance samples. The experimental requirements are high DC bias currents (typically 10mA) together with high AC sensitivity (pA/VHz). This system is used to investigate the shot noise in Superconductor/Normal/Superconductor junctions where Andreev reflection enhanced shot noise is expected. Because our setup has an intrinsic noise much smaller than the thermal noise of the resistance bridge at 4.2K, reliable results can be obtained on impedances out of the range of classical measurement schemes.
Create a lesson
Related papers
Distinguishing Quantum Capacitance Signatures of a Topological Majorana Wire from a Normal Wire Segment
Binayyak Bhusan Roy, Jay Deep Sau, Sumanta Tewari
Band's Geometry Origin of Quantum Spin Transport Phenomena
Elena Derunova, Mazhar N. Ali
Trapping e/4 quasiparticles in bilayer graphene
Mario Di Luca, Emily Hajigeorgiou, Ning Ma et al.
Scalable, Simple, and Versatile Encapsulation of 2D Materials and Devices
Gabriel Natale, Uma Chirkova, Flávio Henriques Feres et al.
Mobility Enhancement in Si/SiGe Quantum Well Enabled by a Buried Si Layer Trapping Oxygen Impurities
Felix Reichmann, Alberto Mistroni, Fabian Fidorra et al.
Occupation-Driven Josephson Diode in a Symmetric Junction
Jianxiong Zhai, Zelei Zhang, Jiawei Yan